![]() The new line sets the script to run on _ispBillingDay of each month (or defaults to 1 if `_ispBillingDay` has not been set. Will look at files after midnight chores. I should have removed that from the zip file. To launch YAMon manually, enter `/opt/yamon4/startup.sh`. YAMon4.0.0 is now configured and ready to run. *** & copied previous file to `/opt/yamon4/config.old`Ĭat: can't open '/opt/yamon4/default_config.file': No such file or directory *** Saved configuration settings to `/opt/yamon4/config.file` opt/yamon4/setup4.0.0.sh: line 588: copyfiles: not found > specified path to _dnsmasq_leases (/tmp/dhcp.leases) does not exist > specified path to _dnsmasq_conf (/tmp/etc/nf) does not exist opt/yamon4/setup4.0.0.sh: line 565: setWebDirectories: not found It appears to be hard coded to 5 in start-stop.sh.Ĭhange to config "_Strangely it did take the change to "_webIndex='index4.html'". I've see the kernel socket message occasionally on my router too but it doesn't seem to affect things.Ĭhanging ISP billing date in config is not picked up and stays day 5. As well, at this point, I've got a lot of perhaps extraneous logging statements The logs should/will get (a lot) smaller when loglevel is changed from 0 to 1 or higher. Which email addy do you prefer large amounts of data come to? I have 4. Last edited by ddaniel51 on Thu 5:47 edited 1 time in total opt/yamon4/update-reports.sh: line 152: arithmetic syntax error The only possible conflict would be in the symlinks in /tmp/wwwĬould not open socket to kernel: Address family not supported by protocol All the files go into separate folders, the iptables entries are also separate. What is needed to let Y3 & Y4 run concurrently?ĭ/dd-wrtv2/downloads/betas/ (Brain Slayer) I've built some limited filtering into the logs and the errors are highlighted in bold red text so it should be much easier to find out when and were issues occur. In addition, the logs are html and can be viewed in a browser (typically 192.168.1.1/user/logs/.html). One of the biggest improvements (if I may say so myself) is that after a mere 6 years, I finally figured out how to incorporate system error messages right into the logs. ![]() ![]() The reports pages will open but will throw a JS error almost immediately. The reports are a whole other can of worms. this beta is focussed on the router-side scripts which collect the data. I've been developing and testing under both DD-WRT, Turris and LEDE (the latter two being OpenWrt variants).įor install instructions and a link to the installer, see and/or. Posted: Mon 17:47 Post subject: YAMon v4. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |